FASCIA Honda Civic 01 to 06 SILVER

This fascia is specifically designed to fit Honda Civic models. To confirm that this is the fascia you require please use the What Fits My Car page.

This fascia is a single DIN fascia meaning that you can only fit single DIN stereos.

Compatible Vehicles

• Honda Civic MK VII 2000-2005

Removing the factory radio:
Start by removing the gear knob and gaiter, unclip the lover part of the console and slide over the gear stick, disconnect the cigarette lighter and hazard switches open the glovebox, squeeze the sides in to fully swing the glovebox open, you'll need a torch to see in but there are two bolts that hold the radio in place on either side, the drivers side bolt will require removal of the under panel below the wheel and the the right of the centre console before you can access it. Once these bolts have been removed, starting from the bottom, pull forward the entire centre console, unclip the wiring harness and air con conecters.

A vehicle's dashboard is the focal point of the entire interior, car manufacturers therefore go to great lengths to ensure it looks stylish and innovative. That is all well and good until you want to upgrade the factory radio to a new aftermarket stereo. Alongside the necessary wiring adaptors Celsus provide fascia plates, plastic surrounds that sit around an aftermarket stereo and neatly match the original vehicle dash.

Aftermarket stereos come in three sizes: single DIN, double DIN and double ISO. All three are the same width, approximately 180mm, but the height differs. Single DIN radios are approximately 50mm high while double DIN and double ISO are twice that at around 100mm. Double DIN and double ISO stereos are the same, but the cages supplied with them have different heights of 103mm and 113mm respectively.